If you begin to feel boring on the old floor, use the parquet. Try the parquet which made from wood. The installation was easier and faster.

Want to change the look of the house floor? No need to bother. You simply covering the old floor with the new floor. The simple way to covering the floor is using Timber Parquet. Whatever the type of your old floor, no problem.

Timber Parquet has many advantages. It was easy to install and relatively faster than the solid wood parquet. Timber Parquet also have long age and anti thermite. And it is easy to take care of it.

If you get bored with the look of its motives, there are a variety of other motifs that can be chosen to replace it. And also not too difficult if you want to remove parquet floor, and back to the old floor.

Here’s the installation steps to set up Timber Parquet on the floor :

1. Clean up the old floor.
2. Put layer of 3mm stereofoam, to cover the entire surface of the floor.
3. Measure the need for parquet floors. Adjust the length and width with an area of room. If the size of parquet pieces is too long, cut it with a hacksaw.
4. Put the parquet floor. Start from the middle of the room. The parquet arrangement should follows the pattern of brick wall. Arrange the parquet according its motive. If you use the parquet rail system, unite the blades of parquet rail. Put a special glue for parquet so it would not easily separated or shifted.
5. After parquet installed, cover the edges – the border area of the floor with the bottom wall of the house – with a sealant or lis. Parquet floor was finished.

This entry was posted on Saturday, May 15th, 2010 at 5:30 pm and is filed under Accessories. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.